Aircraft Training Program

Aircraft Training Program
AeroSIM RC is designed as a Training aid for those who want to learn to pilot a RC model.
There is no prerequisite. The training is oriented to the beginner without any previous knowledge of RC.
The beginner will learn to control the model in the air, and also to take off, and land in one piece.
Nowadays a RC simulator plays a very important role during the starting stages of RC learning. A great help in acquiring most of the required skills. All this is possible since many hours of practise can be flown with no repair time or cost involved, without any stress, and by performing manoeuvres that would be risky for a beginner, such as dead stick landings, o flying an out-of-trim model.
AeroSIM RC's Training Program is based on the BMFA requirements for Certificate 'A' exam, and in the recommendations from experienced instructors who have taught many modellers what it takes to fly solo.
The Lessons
A few examples of the kind of exercises included in the training program.
![]() Control Familiarisation |
![]() Flying through Rings |
![]() Model flying toward the pilot, the right and left are reversed. |
![]() Landing |
![]() Circles |
![]() Figure of Eight |
![]() Take Off |
![]() Taxi |
The Program
The syllabus is composed of 63 exercises classified in five subjects: Controls, Taxi, Take-off, Landing and Flight Patterns (i.e. circles, and eights)
The model used for the training is a high-wing trainer model with a size .40 engine.
The exercises are seasoned with left and right direction of flight, in order not to get used to only one direction, winds from calm to severe winds, and cross winds, camera viewpoints, and engine failures or out-of-trim models.
The Training Program guides you through the lessons in a predetermined order. If you fail several times a lesson, the training continues to the next lesson in the program. There can be a limited number of lessons pending, but at least you will not be frustrated with any particular lesson in case it takes more attempts before you acquire the skills to pass it.
The cheat button will unlock all lessons.
You can always practise again the lessons you have already passed.
When all lessons are completed you will receive a certificate.

Lesson selection menu
The lessons already passed are displayed in green.
The lessons attempted but failed are shown in red.
The lesson in blue is the next recommended one.
There is a red dot for each time the lesson was failed.
There is a green dot for each time the lesson was passed.












